Electrolux EW30GS75KSD Installation Instructions Manual page 3

30" gas slide-in range with sealed top burners
Table of Contents

Advertisement

Available languages

Available languages

To avoid
breakage:
Do NOT handle
or manipulate
the unit by the cooktop.
The counter-top
around the cut-out should be flat and leveled (see
hatched area on illustration
1).
Before installing the unit, measure the heights of the two (2) cabinet
sides (H1-4), front and back (see illustration
1) from the floor to the top
of the counter.
Level the range using the
Shave
1 1/2"
Max.
1
two (2) front leveling legs
Raised
(3.8cm Max.) I
and the two (2) adjustable
Edge
leveling wheel, so that the
to Clear
height from the floor to
Space
for
the underside of the metal
311/2"
(81 cm)
flange is greater than the
Wide
Cooktop.
tallest cabinet measurement
by at least 1/16" (see
illustration
2).
Remove and discard the two rear leveling legs, they are only in place to
solidify the unit for the transport.
Slide the unit into the cabinet. Make sure the center of the unit is aligned
with the center of the cabinet cut-out.
Illustration
1
Remove the protective
channels on each side of the cooktop (if provided).
The metal flange under each side of the cooktop
MUST be placed over
the cabinet countertop
for proper unit support.
The cooktop
should
NOT rest directly on the countertop
(see illustration
2) or else it could
cause damage to the cooktop voiding the warranty.
Level the unit if
needed.
After the installation, MAKE SURE that the unit is
supported
by the two front leveling legs and the
two adjustable leveling wheels and NOT by the
cooktop.
successfully
install the
range, the initial
level height
from floor to
underside of
cooktop frame
should be at
least 1/16"
taller than
sides
as measured in
step 2.
Illustration
2
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents