Frigidaire FFF335ESF Installation Instructions Manual

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Clearances and Dimensions
1. Provide adequate clearances between the range and adjacent combustible surfaces.
2. Location--Check location where the ranqe will be installed. Check for proper electrical supply, and the stability
of the floor.
3. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must
be solid and level.
FRONT _ ..................... _.....................
_ 30t" 30"-I_
Minimum _
Minimum to
wall on either 1"4_
side of range
above 36" height.
30"
t Minimum to
18" cabinets on
either side
of range.
SIDE
VIEW
1÷13"÷1
Maximum depth r
for cabinets [,"
above range top. L_
!ii_ I i i_iiii ii i ;
0" clearance below cooking top and at rear of range.
RANGE
OVERALL
DIMENSIONS
253!4"
47-3/4" I
L_-_ _S_--_ I I
Maximum
I
I /
I 36+1/8'
Door Open _4_-_
,,
_29 7/8".....
....
Centerline
of range
Dashed cubed area
shows where the electrical
outlet must be installed
2-5/8" for models equipped
with warmer drawers"
3-1/2" for models equipped
with storage drawers
Wall
Edge
*30" MINIMUM CLEARANCE BETWEEN THE TOP OF THE COOKING SURFACE AND THE BOTTOM OFAN UNPROTECTED WOOD
OR METAL CABINET; OR 24" MINIMUM WHEN BOTTOM OF WOOD OR METAL CABINET IS PROTECTED BY NOT LESS THAN 1/
4" FLAME RETARDANT MILLBOARD COVERED WITH NOT LESSTHAN NO. 28 MSG SHEET STEEL, 0.015" STAINLESS STEEL, 0.024"
ALUMINUM OR 0.020" COPPER. 0" CLEARANCE IS THE MINIMUM FOR THE REAR OF THE RANGE. FOLLOW ALL DIMENSION
REQUIREMENTS PROVIDED ABOVE TO PREVENT PROPERTY DAMAGE, POTENTIAL FIREHAZARD, AND INCORRECT COU NTE RTOP
AND CABINET CUTS.
TO ELIMINATE THE RISK OF BURNS OR FIRE BY REACHING OVER HEATED SURFACE UNITS, CABINET STORAGE SPACE
LOCATED ABOVE THE SURFACE UNITS SHOULD BE AVOIDED. IF CABINET STORAGE IS TO BE PROVIDED, THE RISK CAN
BE REDUCED BY INSTALLING A RANGE HOOD THAT PROJECTS HORIZONTALLY A MINIMUM OF 5" BEYOND THE
BOTTOM OF THE CABINETS.
P/N 316259201 (0106) 1 Espa_ol - Paginas 5-8