Advertisement
This appJiance is equipped
with a 4-
prong grounding
plug for your protection
against
shock hazard, and should
be plugged
directly
into a
properly
grounded
receptacle.
Do not cut or remove
the ground
prong from this plug.
FOR MODELS WITH SELF-CLEAN FEATURE:
Remove broiler
pan, food and other utensils
before self-cleaning
the oven. Wipe up excess
spillage. Follow the precleaning instructions in the Use
and Care Guide.
Factory
Connected
Power
Supply
Cord
This range is equipped with a factory-connected
power
cord (see Figure 1). Cord must be connected to a
grounded 120/240 volt or 120/208 volt range outlet. If
not outlet is available, have one installed by a qualified
electrician.
Figure 1
Electrical
Shock Hazard
• Electrical
ground
is required
on this appliance.
• Do not connect
to the electrical
supply untit
appJiance is permanentJy
grounded.
• Disconnect
power
to the circuit breaker
or fuse
box before
making
the eJectricat connection.
• This appliance
must be connected to a
grounded,
metallic,
permanent
wiring
system,
or a grounding
connector
shouJd be connected
to the grounding
terminat
or wire lead on the
appliance.
• Do not use the gas suppty line for grounding
the appliance.
Failure to do any of the above could resutt in a
fire, personal
injury
or electrical
shock.
Range
Placement
To eliminate the risk of burns or fire by
reaching over heated surface units, cabinet storage
space located above the range should be avoided. If
cabinet storage space is to be provided, the risk can be
reduced by installing a range hood that projects
horizontally a minimum of 5" (12.7 cm) beyond the
bottom of the cabinet.
Center
Line of
Range
Follow instructions
for
the type of installation
you have
Figure
2
tf range
will
be installed
with
a cabinet
on both
sides,
draw
a center
line on tile floor
between
the
cabinets
(see figure
2). If back of range
will
not
be
flush
with
the wall
(the location
of the outlet
may not
allow the range to be positioned
against
the wall), draw
a line on tile floor
where
the back edge of the range will
be. Now install
anti-tip
brackets
(see "Anti-tip
Brackets
Installation
", page 8).
tf range will be installed
with a cabinet on one side
only, move the range into final position. Draw a line on
the floor along the side of tile range that is not against
tile cabinet. If back of range wilt not be flush with
the wall (the location of the outlet may not allow tile
range to be positioned against the wall), draw a line on
the floor where the back edge of the range will be. Now
install anti-tip brackets (see "Anti-tip
Brackets
Installation ", page 8).
tf range will not be installed
against
a cabinet,
move range into final position. Draw a line on the floor
along both sides of the range. If back of range will
not be flush with the walt (the location of the outlet
may not allow the range to be positioned against the
wall), draw a line on the floor where the back edge of
the range will be. Now install anti-tip brackets (see
"Anti-tip
Brackets Installation ", page 8).
Advertisement
