Advertisement
Toreduce the riskof tippingofthe range, t he range
mustbesecured t o thefloorbyproperly installed a ntPtip
brackets a ndscrews packed withthe range. T hose parts
arelocated in a plastic: baginthe oven.Failure t o install
tile antPtipbrackets w ill allowthe range to tip overif
excessive weightisplaced onanopendooror if a child
climbs uponit. Serious i njurymightresult f romspilled
hot liquids orfromthe range itself.
Follow theinstructions b elowto install t he antPtip
brackets.
If range isevermoved to a different l ocation, t he antPtip
brackets m ustalsobemoved andinstalled withthe
range. T ocheck for properinstallation, seestep5.
ToolsRequired:
5/16" (8 ram)Nutdriver or FlatHead Screwdriver
Adjustable W rench
Electric Drill
3/16" (4.8ram)Diameter DrillBit
3/16" (4.8ram)Diameter Masonry D rillBit(if installing
in concrete)
Anti-tip
Bracket
Installation
Brackets attach to the floor at the back of the range to
hold both rear leg levelers. When fastening to tile floor,
be sure that screws do not penetrate electrical wiring or
plumbing. The screws provided will work in either wood
or concrete.
1.
Unfold paper template and place it flat on the floor
with the back and side edges positioned exactly
where the back and sides of range will be located
when installed. (Use the diagram in figure 7 to
locate brackets if template is not available.)
2.
Mark on tile floor the location of the 4 mounting
holes (2 holes per bracket) shown on the template.
For easier installation, 3/16" (4.8 ram) diameter pilot
holes 1/2" (1.3 cm) deep can be drilled into the
floor.
3.
Remove template and place brackets on floor with
turned up flanges to the outside (see figure 7). Line
up holes in brackets with marks on floor and attach
with 4 screws provided (2 screws per bracket).
Brackets must be secured to solid floor. If attaching
to concrete floor, first drill 3/16" (4.8 ram) dia. pilot
holes using a masonry drill bit.
4.
Level range if necessa% by adjusting the 4 leveling
legs with a wrench. (See Figure 8 below.) A
minimum clearance of I/8" (3.2 ram) is required
between the bottom of the range and the rear
leveling legs to allow room for the anti4ip brackets.
5.
Slide range into place making sure rear legs are
trapped by ends of brackets. Range may need to be
shifted slightly to one side as it is being pushed back
to allow rear legs to align with brackets.
6.
After installation, verify that the anti4ip bracket is
engaged. Open and remove drawer and check to
make sure the anti4ip bracket is engaged.
_Slide
Back
AntPtip Bracket
Sides of
range
Figure 7
Leveling Leg
_Raise
Figure 8
\
Advertisement
