For Models With Self-Clean Feature - Frigidaire FGFL77ABC Installation Instructions Manual

30" gas range (for models with sealed top burners)
Hide thumbs Also See for FGFL77ABC:
Table of Contents

Advertisement

Important
Notes to the Installer
1.
Read all instructions contained in these installation
instructionsbefore installingrange.
2.
Removeallpackingmaterialfromtheovencompartments
before connecting the gas and electrical supply to the
range.
3.
Observe all governing codes and ordinances.
4.
Be sure to leave these instructions with the consumer.
Important
Note to the Consumer
1.
Keep these instructions with your owner's guide for
future reference.
IMPORTANT SAFETY
INSTRUCTIONS
Installation of this range must conform with local codes or, in
the absence of local codes, with the National Fuel Gas Code
ANSI Z223.1--1atest edition when installed in the United
States,
This range has been design certified by CSA International.
As with any appliance using gas and generating heat, there
are certain safety precautions you should fellow. You will find
them in the Use & Care Manual. read it carefully.
Be sure your range is installed and grounded properly
by a qualified installer or service technician.
This range
must be electrically
grounded
in
accordance with local codes or, in their absence,
with the National Electrical Code ANSI/NFPA No .70_
latest edition when installed in the United States.
See Grounding Instructionson page 5.
Before installing the range in an area covered with
linoleum or any other synthetic floor covering, make
sure the floor covering can withstand heat at least
9O°F above room temperature without shrinking,
warping or discoloring. Do not install the range over
carpetingunless you place an insulatingpad or sheet of
1/4-inch thickplywoodbetween the rangeand carpeting.
Make sure the wall coverings around the range can
withstand the heat generated by the range.
Do not obstruct the flow of combustion air at the
oven vent nor around the base or beneath the lower
front panel of the range. Avoid touching the vent
openings or nearby surfaces as they may become hot
while the oven is in operation. This range requires fresh
air for proper burner combustion.
Never leave children alone or unattended
in the area where an appliance is in use, As childrengrow,
teach them the proper, safe use of all appliances. Never
leave the oven door open when the range is unattended.
Stepping, leaning or sitting on the doors
or drawers of this range can result in serious injuries and
can also cause damage to the range.
Do not store items of interest to children in the
cabinets above the range. Childrencould be seriously
burned climbingon the range to reach items.
To eliminate the need to reach over the surface
burners, cabinet storage space above the burners
should be avoided.
Adjust surface burner flame size so it does not
extend beyond the edge of the cooking utensil.
Excessive flame is hazardous.
Do not use the oven as a storage space. This creates
a potentially hazardous situation.
Never use your range for warming or beating the
room. Prolonged use of the range without adequate
ventilation can be dangerous.
Do not store or use gasoline or other flammable
vapors and liquids near this or any other appliance.
Explosionsor fires could result.
Reset all controls to the "off" position after using a
programmable timing operation.
FOR MODELS WITH SELF-CLEAN FEATURE:
Remove broiler pan, food and other utensils before
self-cleaning the oven. Wipe upexcess spillage. Follow
the precleaning instructionsin the Owner's Guide.
Unlike the standard gas range, THIS COOKTOP IS
NOT REMOVABLE. Do not attempt to remove the
cooktop.
DO NOT MAKE ANY ATTEMPT
TO
OPERATE THE ELECTRIC IGNITION OVEN DURING AN
ELECTRICAL POWER FAILURE. RESET ALL OVEN
CONTROLS TO "OFF" IN THE EVENT OF A POWER
FAILURE.
The electric ignitor will automatically re-ignite the oven
burner when power resumes if the oven thermostat contr,
was left in the "ON" position.
When an electrical power failure occurs during use, the
surface burners will continue to operate.
During a power outage, the surface burners can be lit with
a match. Hold a lighted match to the burner, then slowly turn
the knob to the LITE position. Use extreme caution when
lighting burners this way.
2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents