Advertisement
LevelMg
the Range
Level the range and set cooktop
height
before
installation
in the cut-out
opening
(if appJicabJe).
1.
Install an oven rack in the center of tile oven.
2.
Place a level on the rack (see figure 4). Take 2
readings with the level placed diagonally in one
direction and then the other. Level tile range, if
necessary, by adjusting the 4 leveling legs with a
wrench (see Figure 8).
3.
Slide range into cut-out opening and double check
for levelness. If the range is not level, pull unit out
and readjust leveling legs, or make sure floor is level.
Figure 4
Check Operation
Refer to the Use and Care Guide and the Electronic
Oven Control Guide packaged with tile range for
operating instructions and for care and cleaning of your
range.
Remove all packaging from the oven before testing.
1.
tnstall
Burner Bases and Burner Caps
This range is equipped with sealed burners as shown
(see Figure 5).
Burner Ca_
(
Figure 5
a.
Unpack burner bases and burner caps.
b.
Place burner bases over each gas opening.
c.
Make sure the burner is properly
aligned and
leveled.
Place burner
caps over appropriate
burner bases.
NOTE: There are no burner adjustments necessary
on this range.
Advertisement
