GE JGSP23 Installation Instructions Manual page 16

Installation Instructions
Making the L.P. Gas Conversion
Adjusting the Cooktop Burners Low Flame Setting
Low setting adjustments must be made with two other burners in operation on a medium
setting. This procedure prevents the low flame from being set too low resulting in the flame
being extinguished when other burners are turned on.
a. Remove the valve control knobs.
b. Through the opening, insert small screwdriver through access hole in valve switch.
Engage adjustment screw in valve. Screw down fully, in the clockwise rotation, the
by pass screw.
[_ Adjusting the Oven Burners
(
Failure to do so could result in serious injury due to high flames and toxic fumes.
CAUTION: The following adjustments must be made before turning on the gas to the burner. 1
BAKE BURNER
2 Screws
1. Remove the oven bottom.
2. Remove the two screws securing burner baffle (flame spreader).
3. Remove the burner baffle (flame spreader).
4. Remove the orifice fitting cover.
IMPORTANT: Do not overtighten or you may bend the orifice hood or needle.
5. Use a 1/2" open end or adjustable wrench to turn the
orifice hood in the LP. direction, about one and one-half
turns, until snug.
NAT.
Orifice Fitting
BROIL BURNER
Use a 1/2" open end or adjustable wrench to turn the orifice hood in the L.P.
direction, clockwise about one and one-half turns, until snug.
NAT.- LP.
ADJUSTMENT /
MADE TO ORIFICE HOOD
16
NAT.