GE JGSP23 Installation Instructions Manual page 15

Installation Instructions
Making the L.P. Gas Conversion
--_ djusting the Cooktop
Burners
a. Removing the top
grates, burner caps
_-BURNERGRATE
------ BURNER CAP
MIXER TU BURNER HEAD
BURNER ////_ _/_£_-,--_ S P AR K IGNITER
_ _ _ MIXER TUBE
(CHIMNEY)
b. Using a 7mm or 9/32" nut driver, remove the top
burner orifices. These may be accessed through
the burner air/gas mixer tube. (chimney)
MIXER TUBE (CHIMNEY)
NOTE: The orifices have a spring loaded
retaining ring around the hex head to hold the
orifice in the nut driver during installation and
removal. A slight amount of force is required
to push the nut driver down over the ring.
r_ Locate the L.P.Orifices
IMPORTANT: Save these orifices for /
future conversion back to natural gas.
J
The L.P. orifices are shipped attached to the
riange on the area behind the storage drawer.
Remove storage drawer to see. Each orifice will
also show a series of engraved marks, (I,II or III),
located on tne top
OOO
These marks denote the precise location of
each orifice to the cooktop burner.
Installing the L.P. Orifices
Install the L..P. orifices in their precise locations.
PORCELAIN COOKTOP
Front of Range
GLASS COOKTOP
Front of Range
Return the natural orifices to the bracket and
reattach the bracket and these instructions to the
pressure regulator using the screw previously
removed.
15