C-MOR IP Video Surveillance User Manual page 46

C-MOR
Time-controlled recordings
Setting of hour and day per week when recordings have to be carried out. This applies e.g. when
recordings should only be carried out during nighttime at a store.
Time-controlled motion detection
Definition of hour and day per week when motion detection should be carried out.
Configuration of camera event for network alarms
Recordings by C-MOR can be triggered by the use of external switches (special accessories) that
report events over your network. Here it is necessary to use an IP switch, which is sending
messages to C-MOR via the so-called syslog service. This will then start a recording for the
camera in question.
Image mask for the definition of the area of motion detection
In case motion should not be detected within the complete camera image the area where motion
should be detected (white area) can be defined by a black & white mask. The defined black area
will not trigger motion detection. The size of the image mask has to be identical to the size of the
camera image.
General information about motion detection:
Motion detection carried out by C-MOR is based on differences in the respective camera image and not
due to conventional motion detectors (exception: special accessory external switch). Motion detection
can also be effected by changes in light.
User Manual Page 46