Installation Instructions - Monogram ZFGB21HZBSS Installation Instructions Manual

Installation Instructions
WARNING
Under certain circumstances, this refrigerator
can tip forward.
Injury to persons can result.
Install Anti-Tip Bracket packed with this refrigerator.
[STEP i MEASURE CABINET OPENING
AVAILABLE VS. REFRIGERATOR
WIDTH
Measure width of cabinet opening where refrigerator
will be placed, W.
Be sure to account for ang countertop overhang,
baseboard thickness and ang clearance desired.
Width, W, should not be less than :36inches.
The refrigerator will be placed approximatelg
in the middle of this opening.
i
i
i
i
i
141
RearWall
W
REFRIGERATOR
i
i
i
i
Baseboard
Thickness
or Countertop
Overhang
(Whichever
is Greater)Plus
AnyDesired
Clearance
RHSide
Front
iSTEP 2i LOCATE ANTI-TIP BRACKET
A. Place the anti-tip floor bracket Iocutor template
(included inside the anti-tip kit) onto the floor up
against the rear wall, within W, and in line with the
desired location of the RH side of the refrigerator
(see Figure !).
Figure I - Installation Overview
Floor- Concrete 2 Wall Holes
(2 Holes) Floor-Wood '_ FloorBracket
.................. ( 2 Holes) /to Install
RHHoles
Rear R H
- -- _ Corner of
Base / - _ Locater
Bracket on . --J-- " _ Template C abinet Wall
-- "_ Side of
theRefrigerator _ Sheet
Refrigerator
B. Place the anti-tip floor bracket onto the Iocator
template with its RHfloor holes lined up with the
floor holes indicated on the template sheet, approxi-
matelg 7-1/4" from the edge of the sheet or the RH
side of the refrigerator.
C. Hold down in position and use the anti-tip floor
bracket as a template for marking the holes based
upon gout configuration and tgpe of construction
as shown in Step 3. Mark the hole locations with
a pencil, nail or awl.
NOTE: It is REQUIRED to use at least 2 screws to
mount the floor bracket (one on each side of the
anti-tip floor bracket). Both must be into either
the wall or the floor. Figure 2 indicates all the
acceptable mounting configurations for screws.
Identifg the screw holes on the anti-tip floor bracket
for gout configuration.
5