Step 1/4,Level Refrigerator; Step 15, Level Doors - Monogram ZFGB21HZBSS Installation Instructions Manual

Installation Instructions
STEP 14 LEVEL THE REFRIGERATOR
Adjust the Rollers
The refrigerator can be leveled by adjusting the rollers,
front and rear.
Rollers heve three purposes:
. The rollers adjust so that the door closes easilg when
opened about halfwag. (Raisethe front about 5/8"
[16 mm] from the floor.)
. Rollers adjust to allow the refrigerator to be firmlg
positioned on the floor and to prevent rocking
when the doors are opened and closed.
. The rollers allow gou to move the refrigerator from
the wall for cleaning.
To Adjust the Rollers:
. Use a 3/8" hex socket or wrench to turn
the adjustment screws. Turn the screws clockwise
to raise the refrigerator, turn counterclockwise
to lower it.
. Use a 5/16" hex socket to turn the screws for
the rear rollers. Turn the screws clockwise to raise
the refrigerator, counterclockwise to lower it.
............. J
..... J
RearRoller FrontRoIler_ _v
Adjustment Adjustment\ L eling
Screw Screw \ Leg
FrontRoller
Adjust the Leveling Legs
The leveling legs heve two purposes:
. Leveling legs adjust so the refrigerator is firmlg
positioned on the floor and does not wobble.
. Leveling legs serve as a stabilizing brake to hold
the refrigerator securelg in position during operation
and cleaning. The leveling legs also prevent
the refrigerator from tipping.
Turn the leveling legs clockwise to raise the refrigerator,
counterclockwise to lower it.
ACAUTION: To avoid possible personal
injurg or propertg damage, the leveling legs must be
firmlg touching the floor.
APRUDENCE
: Afin d'_viter toute
blessure corporelle ou dommage materiel, les pieds de
support doivent _tre en contact avec le sol.
STEP 15] LEVEL THE DOORS
If the doors are not evenlu aligned at the top,
the refrigerator door can be adjusted.
. Use a 7/16" hex socket or wrench to turn the door
adjusting screw. Turn the screw to the right to raise
the door, turn left to lower the door.
Doors Should
at Top
NOTE:A nuIon plug is imbedded in the threads of
the pin. The plug is designed to prevent the pin from
turning. A wrench must be used to turn the pin.
. Turn the wrench one or two times. Open and
close the refrigerator door to check alignment with
the freezer door at the top. Adjust again if necessary.
13