Step 5, Install Blower Motor; Step 6, Connect Wiring Harness - Monogram ZVC42 Installation Instructions Manual

Installation instructions
ISTEP 51 INSTALL BLOWER MOTOR
1, Pick up blower motor and rotate so tabs align
with damper plate bracket.
2, Insert blower motor into insert sleeve through
cutout opening of custom cabinet frame.
3, Place blower motor on damper plate assemblg
bg sliding blower motor tabs into slots of damper
plate assemblg.
O Q Q Q O,
I
4, While holding blower motor in place, lift right side
so that blower motor bolt holes align with bolts
protruding from damper plate assemblg and
secure with lock washers and wing nuts (hand
tighten).
ISTEP 6 ICONNECTWIRING HARNESS
NOTE:Connect three routing clips annd two wiring harnesseson double blower models.
Wiring
harness ooooo
1. Locate both ends of wiring harness.
2. Connect wiring harness bg inserting male into
female opening.
Brackets
3. CarefullL route wiring harness and ground wire
through two clips attached to blower plate
assemblg.
21