Step 2, Connect Electrical - Monogram ZVC42 Installation Instructions Manual

Installation Instructions
ISTEP 21 CONNECT ELECTRICAL
Verify that power is turned off at the source.
A WARNING:
if house wiringisnot
2-wire with o ground wire, on electrician will need
to convert existing wiring to meet these specs.
When house wiring is aluminum, be sure to use
U.L-opproved anti-oxidant compound and
aluminum-to-copper connectors.
1. Place insert sleeve on podded, yet stable, surface
below cutout (con use flattened carton to pod
surface).
2. Remove the junction box cover.
00000
\
i OOOO, O
\
Connect
4. Connect white leads to branch circuit white lead.
5. Connect block leads to branch circuit block lead.
6. Connect green/yellow leads to branch circuit green
lead.
7. Secure oil connections with wire nuts.
Wires
3. Pull house wires through wall of insert sleeve and
attach the strain relief. Thread the house wire
through the junction box.
00000
<2
Cover
Screws
8. Carefully push wires into junction box and replace
cover.
9. Secure junction box cover with original screws.
18