Remote Mounting Of The Control - Wired - Monogram ZVC42 Installation Instructions Manual

Installation Preparation
REMOTE MOUNTING OF THE CONTROL - WIRED
A WARNING: Disconnect electrical
power from unit before beginning remote control
installation. Failure to do so could result in personal
injurg or damage to the electrical controls.
1-11/!6"
-- 3-11/16"
Control cutout
REMOTE LOCATION FOR CONTROL
NOTE: The hood is onlg certified for use with the
supplied 30-ft. length of wire.
The control can be removed from the hood and
installed in a backsplash or countertop.
, A cover plate is provided to cover the opening in
the hood when the control is removed.
A 30-ft. length of 4-wire cord is supplied to
accommodate most installations. Because onlg
30-ft. of cord is provided, careful consideration
must be given to the location of the remotelg
mounted control.
, The 30-ft. cord is supplied with a connector/
converter on one end. DO NOT REMOVE the
connector/converter from the 30-ft. cord. Failure
to use the connector/converter with the shorter
cord will prevent proper operation of the control.
NOTE: Not for telecommunication (telephone)
network.
, The cord must be routed through the holes in the
insert sleeve, and the rubber grommets put into
place around the cord.
NOTE: On the ZVC30 and ZVC36 models, the cord
needs to be routed through the holes in the insert
sleeve before the damper plate is installed.
, Route the cord through the conduit to reach the
installation location of the control.
Remotely Mounted Control--Wall or Countertop Installation
[] [][] [][]
Display board
Long cord Connector/ Short cord
converter
Main
PCB
15