Construct Ceiling Support - Monogram ZVC42 Installation Instructions Manual

Island Installation Preparation
CONSTRUCT CEILING SUPPORT Ifor Island Installation)
Plan the Location of the Hood and Ductwork
The ceiling structure must be capable of supporting the
weight of the insert sleeve (approximatelg 100 pounds),
the canopy itself, ang mounting hardware and ang
inadvertent user contact loads.
. Use a plumb bob to check the location.
Thecountertop/cooktop below the insert sleeve must
be centered with the insert sleeve.
Front
Align with
center of
cooktop
Ceiling
, M
ducting
' _ _ ' centerline
"30" Minimum required
*36" Haximum
_', recommended
installation height
t
' Fron view Countertop
*Alwags refer to the cooktop or range installation
instructions for product-specific clearances.
, The insert sleeve in the canopg must be centered
left to right over the cooktop.
"30" Minimum required
*36" Haximum recommended
installation height
L. r "_ j
Left side view
r-
Illustrations not to scale
, If desired, install the control in a remote location
using the supplied mounting hardware. See the
following pages for detailed instructions for
mounting the control remotelg.
, Refer to Ceiling Ducting on page 13 for ductwork
installation.
IMPORTANT: The exhaust outlet in the top of the
insert sleeve is not centered; it is positioned closer
to the back side. Therefore, the insert sleeve mag
not be centered front to back in the canopg. A
custom liner constructed bg the cabinet supplier
is usuallg required for island installations.
NOTE: It is recommended that the custom hood
insert be purchased and on-site before the canopg
is constructed.
14