Installation Preparation; Tools And Materials Required; Remove The Packaging - GE ZVC42L1SS Installation Instructions Manual

Installation Preparation
TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED)
Needle-nose pliers
Aluminized (
duct tape
Pencil and tape measure
Spirit level
Knife
Plumb line
1/4" pivoting L--
hex socket 1" conduit (for remote
mounting only)
Silicone
_ Safety glasses
Gloves
c o(]:
Flashlight
Step ladder
3/8" socket/
nut driver
Wire nuts
Phillips and flat-blade
screwdrivers
Electric drill and
appropriate bits
8" ducting and
Tin snips caps as needed
Wire cutter/stripper Strain relief
REMOVE THE PACKAGING
A CAUTION: Wear gloves toprotect
against sharp edges.
CAUTION:
LIFTTHE INSERT SLEEVE
OUT OF THE BOX BY GRASPING THE SIDES.
1. Open hood carton.
2. Remove the liner, foam and cardboard.
4. Unscrew the 5 nuts securing the damper vent
plate assembly, and remove it from the insert
sleeve. Set the 5 nuts and the damper vent plate
assembly aside, as you will be re-installing it later
in the installation process.
3. Remove the tape securing the filters to the insert
sleeve, lift the tabs and remove the filters.
5. Remove the screws attaching the insert sleeve to
the mounting board. Discard the screws.
6. Grasp the insert sleeve by the outside edges, and
lift straight up and out of the carton.
NOTE: Do not lift the insert sleeve by the blower
motor.
7. Remove and properly discard the plastic wrapping.
8. Remove the parts box and other packaging.
11