GE ZVC42L1SS Installation Instructions Manual page 2

Installation Instructions
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
, IMPORTANT- save
these instructions for
local inspector's use.
"IMPORTANT-Observe
all governing codes
and ordinances.
, Note to Installer - Be sure to leave these
instructions with the Consumer.
, Note to Consumer - Keep these instructions for
future reference.
, Skill Level - Installation of this vent hood requires
basic mechanical and electrical skills.
, Completion time- 1to 3 hours.
, Proper installation is the responsibility of the
installer.
, Product failure due to improper installation is not
covered under the Warranty.
For Monogram local service in your area, call
1.800.444.1845.
For Monogram service in Canada, call
1.800.561.3344.
For Monogram Parts and Accessories, call
1.800.626.2002.
ACAUTION:
Due to the weight and size of these vent hoods
and to reduce the risk of personal injury or damage
to the product, TWO PEOPLE ARE REQUIRED FOR
PROPER INSTALLATION.
AWARNING:
To reduce the risk of fire or electrical shock, do not
use this range hood with any external solid-state
speed control device. Any such alteration from
original factory wiring could result in damage to the
unit and/or create an electrical safety hazard.
TO REDUCE THE RISK OF FIRE, USE ONLY METAL
DUCTWORK.
A WARNING: TO REDUCE THE R ISK OF
FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
A. Use this unit only in the manner intended by the
manufacturer. If you have questions, contact the
manufacturer.
B. Before servicing or cleaning unit, switch
power off at service panel and lock the service
disconnecting means
to prevent power from being switched on
accidentally. When the service disconnecting
means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the
service panel.
A CAUTION: For General
Ventilating
Use Only. Do Not Use To Exhaust Hazardous Or
Explosive Materials And Vapors.
A WARNING: ToREDUCE THE R ISK OF
FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
A. Installation work and electrical wiring must be
done by qualified person(s)in accordance with all
applicable codes and standards, including fire-
rated construction.
B. Sufficient air is needed for proper combustion
and exhausting of gases through the flue
(chimney) of fuel burning equipment to prevent
back drafting. Follow the heating equipment
manufacturer's guideline and safety standards
such as those published by the National Fire
Protection Association (NFPA), and the American
Society for Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE),and the local
code authorities.
C. When cutting or drilling into wall or ceiling, do
not damage electrical wiring and other hidden
utilities.
D. Ducted fans must always be vented to the
outdoors.
. Local codes vary. Installation of electrical
connections and grounding must comply with
applicable codes. In the absence of local codes,
the vent should be installed in accordance with
National Electrical Code ANSI/NFPA 70-1990 or
latest edition.