Alto CYCLONE User Manual page 25

[ Cyclone Master Section ]
The aux send section is useful to control the overall level of the send to a monitor speaker or to an effects unit.
Generally pre-fader is used for monitor purposes, allowing the sound engineer to set a level that's independent by
channel fader setting. In this way the control will be much more accurate and the sound engineer doesn't risk unwanted
feedback when, for example, he raises the level of the lead singer. Post-fader sends are better suited for FX sends
control. By doing so, for example, the sound engineer will raise the fader level of the lead singer the effect send as
well, maintaining the same sound balance between "dry" & "wet" signals. Please note that the channel Mute switch
affects these controls.
PRE switch
Press this pre-fader switch, the signal is sent out before all
channel faders and will not be affected by each channel fader.
AFL switch
This switch allows the sound engineer to control the AUX send
signal. AFL is the acronym of after-fade listen, the signal is
post-fader. The LED next to this large switch is illuminated
to give you an immediate visual check of current status.
AUX 1
The AUX 1 send level can be adjusted from -
AUX 2
The AUX 2 send level can be adjusted from -
AUX 3
The AUX 3 send level can
AUX 4
The AUX 4 send level can
AUX 5
The AUX 5 send level can
AUX 6
The AUX 6 send level can
up to +10dB.
up to +10dB.
be adjusted from - up to +10dB.
be djusted from - a up to +10dB.
be djusted from - a up to +10dB.
be djusted from - a up to +10dB.
24
0dB PRE
AUX1
AFL
-
+ 10
0dB
PRE
AUX2
AFL
-
+ 10
0dB
PRE
AUX3
AFL
-
+
10
0dB
PRE
AUX4
AFL
-
+
10
0dB
PRE
AUX5
AFL
-
+
10
0dB PRE
AUX6
AFL
-
+ 10