Digicom Tintoretto User Manual page 26

Description
It is important to remember that the CCITT rules for the asincronus V25bis function,
provide a format of 7 data bit Even parity.
To return in AT command from V25bis command set (%V1 or %V3), turn ON the Tintoretto
pushing the TEST push-button for minimum 5 seconds.
Store: S31 (bit 0, 1, 7)
%Z1 Master reset
Master reset and load the configuration specified by the &Y command.
/N11 Fax and Answering machine incoming call
/R1 Fax and Answering machine enable
/T TEI defination
This command defines if the TEI is fix (point to point) or variable (multipoint).
/T=xx TEI is fix and the variable xx is a number between 00 to 63. This value ,defined by the Telecom operator,
normaly is 00
/T=99 TEI is variable.
After this command Tintoretto must be powered on.
/Z Delete RAM
This command delete the Tintoretto RAM and load the factory configuration 0. Any other user
configurations and telephone number will be erased.
After this command the Tintoretto must be powered ON.
/Z=0000 Erase the RAM
!C0 ISDN type of Network
This command display the type of ISDN used. The value for an Euro ISDN network is 4. This
value must not modified.
Store: yes
!N1= Store Caller Identification number (CALLER ID)
This command enable to store the telephone number for the CALLER ID function.
!N1="nnnn"
!N1?
To enable the CALLER ID function, please also make reference to the AT*I command.
Store: yes
!N2= Store MultiSubscriber number (MSN)
This command enable to store the own telephone number for the MultiSubscriber Number
function.
where "nnnn" is the telephone number without prefix
show the stored telephone number
3.16
Default= %V0
Deault=n/a
Deault=n/a
Deault=4
Default= n/a