Table of Contents
Advertisement
Description
*M
MultiSubscriber Number function (MSN)
The MultiSubscriber Number permits the association of maximum 8 consecutive numbers to
a BRI access of the national plan number. There's a principal number with the last digit always
equal to "0" and associated with it is an auxiliary number that may vary between "1" and "7".
The called Tintoretto checks the incomming called party number with the number stored in its
memory with the AT!N2 command; if the two numbers matched then it answer the call, otherwise
it does not.
In order for this feature to work, the receiver Tintoretto must have the MSN feature enable.
*M0
MultiSubscriber number function disable
*M1
MultiSubscriber number function enable
To insert the MultiSubscriber number into Tintoretto, please make reference to the AT!N2
command.
ATTENTION
The MultiSubscriber is an option feature: verify with your Telecom operator to enable it.
Store: S69 (bit 1)
*S
Subaddress function
The Subaddressing mode allows the identification of the 8 Tintoretto connected to the same
BRI interface for the multinumber. This feature is managed only by the local and remote
Tintoretto. The ISDN network only allows for the delivery of the subaddress field.
The called Tintoretto send telephone number followed the Subaddress field (ATDnnn+sss
where "nnn" is the telephone number and "sss" is the Subaddress field with a maximum of 4
alphanumeric characters); the calling Tintoretto compares the received Subaddress to the
stored Subaddress. If there's a match then it answer the call, otherwise it does not.
In order for this feature to work, both the originator and the receiver Tintoretto must have their
Subaddres feature enable.
*S0
Subaddress function disable
*S1
Subaddress function enable
To insert the Subaddress field into Tintoretto, please make reference to the AT!N3 command.
Store: S70
*X
Clock in Off-Line (only for Tintoretto external)
This command enable the send and receive clock (C114/C115) also when the Tintoretto is Off
line.
The complete string to enable this feature is: &Q2*X1%V3
*X0
Clock available in on line only
*X1
Clock always available
Store: S77 (bit 2)
%A2
Define the CSD call type
Define the rate adaption protocol to be used on the B channel
%A2=1
V.110 protocol.
3.14
Default=*M0
Default=*S0
Deault=*X0
Advertisement
Table of Contents
