Step !2, Connect Water Supplg; Step !5, Connect Drain Line - GE Monogram ZBD1870 Installation Instructions Manual

Installation Instructions
STEP 12 CONNECT WATER SUPPLY
Connect water supplg line to 90 ° elbow.
• Slide compression nut,
CompressionNut
Ferrule
then ferrule over end of
water line.
Insert water line into 90 °
elbow.
Slide ferrule against
elbow and secure with
compression nut.
Figure EE
Hot Water z
_o Elbow SupplyLine
f--<x
IMPORTANT- Check tobe sure t hat d oor
spring
does
not rub or contact the fill hose or water supplg line. Test bg
opening and closing the door. Re-route the lines if a rubbing
noise or interference occurs.
STEP 13 CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODESAND ORDINANCES.
The molded end of the drain hose will fit 5/8" through !"
diameter inlet ports on the air gap, waste tee or disposer.
Determine size of inlet port
Cut drain hose connector on the marked line, if required, to fit
Figure FF
the inlet port.
Cutting Lines
/4
IMPORTANT: Do not cut corrugated
portion of hose
If a longer drain hose is required, add up to 42" of length for
a total of 10' to the factory installed hose. Use 5/8" or 7/8"
inside diameter hose and a coupler to
connect the two
hose ends.
Secure the
connection with
hose clamps. Coupler
Figure GG
Hose Clamp
Hose Clamp
Secure the drain hose to the air gap, waste tee or disposer
with clamps.
Note: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED !0' FOR
PROPER DRAIN OPERATION.
12
DRAIN LINE INSTALLATION
• Connect drain line to air gap, waste tee or disposer using
either previously determined method.
Method 1 - Air gap with waste tee or disposer
Insert the drain hose to air gap as shown.
Waste Tee Installation
Figure HH
Disposer Installation
Method 2 - Drain Hose Routing
Route the drain hose of the dishwasher to a minimum height of 32" from
the floor with the supplied hanger as shown.
Waste Tee Inst Ilati Disposer Installation
m
Figure II
IN PORTANT-
Either one of the above methods
must be used or dishwasher will not operate properlg.
IN PORTANT- When
connecting
drain line to disposer, check to be sure
that drain plug has been removed.
DISHWASHER WILL NOT DRAIN IF
PLUGISLEFT IN PLACE.
[_ 4--- Remove
Hopper
Plug
Tip: Avoid unnecessary service call charges. Always be sure
disposer drain plug has been removed before attaching
dishwasher drain hose to the disposer.