Step 13 Connect Water Supply; Step 14 Connect Drain Line; Drain Line Installation - GE EDW4000 Series Owner's Manual

STEP 13 CONNECT WATER SUPPLY

Connect water supply line to 90 elbow.
• Slide compression nut, then ferrule over end of
water line.
• Insert water line into 90 elbow.
• Slide ferrule against elbow and secure with compres-
sion nut.
IMPORTANT:
Check to be sure that door spring
does not rub or contact the fill hose or water supply
line. Test by opening and closing the door. Re-route the
lines if necessary.

STEP 14 CONNECT DRAIN LINE

FOLLOW ALL LOCAL CODES AND ORDINANCES.
The drain hose molded end will fit 5/8", 3/4" or 1"
diameter connections on the air gap, waste tee or
disposer. Cut on the marked line as required for your
installation.
Cutting Lines
3/4"
1"
IMPORTANT: Do not cut corrugated
portion of hose
• If a longer drain hose is required, add up to 42" of
length for a total of 10 ft. length to the factory installed
hose. Use 5/8" or 7/8" inside diameter hose and a
coupler to connect the two hose ends. Secure the
connection with hose clamps.
Hose Clamp
• Secure the drain hose to the air gap, waste tee or
disposer with clamps.
Note:
TOTAL DRAIN HOSE LENGTH MUST NOT
EXCEED 10 FEET FOR PROPER DRAIN OPERATION.
Installation Instructions
5/8"
Figure W
Hose Clamp
Coupler
Figure X
Figure V
Door Spring

DRAIN LINE INSTALLATION

• Connect drain line to air gap, waste tee or disposer
using either previously determined method.
Method 1 – Air gap with waste tee or disposer
Waste Tee Installation
Method 2 – Built-in "High drain loop" with waste tee or
disposer
18"
Min.
Waste Tee Installation
IMPORTANT:
When connecting
drain line to disposer, check to be
sure that drain plug has been
removed. DISHWASHER WILL NOT
DRAIN IF PLUG IS LEFT IN PLACE.
9
Compression Nut
Ferrule
Hot Water
Supply Line
90 Elbow
90 Elbow
Disposer Installation
Figure Y
18"
Min.
Disposer Installation
Figure Z
Remove
Hopper
Plug