Omnitron Systems Technology iConverter User Manual page 6

1.5.2 Out-of-Band Managed 4-Port Switch Application
Fig 4. Depicts a typical managed switch application.
This application uses a 4TxVT 4-Port 10/100 switch module and an
Management Module (NMM) for management. Both modules are plugged into the
2-Module chassis.
The 4TxVT features four front-plane 10/100BASE-T UTP Ethernet ports and two
10/100Mbps Ethernet backplane ports (A and B Ports).
The NMM features a 10BASE-T front-plane port and a 10Mbps Ethernet backplane A
Port.
Out-of-band management is provided by connecting to the front-plane port on the
NMM module. The management data is separate from the user data on the 4TxVT.
This configuration provides the network administrator with the ability to efficiently and
cost effectively manage a small (4-port) workgroup switch.
2.0 UNPACKING, VISUAL INSPECTION AND INVENTORY
Review contents. The following items should be included:
iConverter
One AC power cord (AC MODULES ONLY)
One DC power connector (DC MODULES ONLY)
User Manual
Inspect equipment and immediately report any damage or discrepancies to Omnitron
at 949-250-6510. If equipment is damaged, do not apply power to the equipment.
"A" Link
A Port
NMM
NMM UTP 4-port 10/100 UTP
10 port
NMM Module
Fig. 4 Managed 4-Port Switch Application
2-Module Power Chassis
Chassis
Backplane
2-Module Chassis
B Port
A Port
does not include
the B Backplane Link
Internal
10/100
switch chip
Switch
4TxVT Module
Page 6
iConverter
Note that the
Network