Built-In Microwave Oven Safety; Installation Requirements - IKEA IBMS1450VMS0 Installation Insrtuctions

BUILT-INMICROWAVE OVEN SAFETY
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
These words mean:
You can be killed or seriously injured if you don't immediately
follow instructions.
You can be killed or seriously injured if you don't follow
instructions.
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
INSTALLATIONREQUIREMENTS
t'O0)S 3_J
Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
• Measuring tape • Electric drill
• Pencil • 5/64" (2 mm) drill bit
• T10 TORX ®tscrewdriver
Parts Supplied
All of the following parts are provided.
A
B
The microwave oven may be located in a cabinet, and/or above a
built-in oven, or below the counter and/or below a non-vented
cooktop. Check the opening where the microwave oven will be
installed. The location must provide:
• Wood cabinetry.
• Cutout opening that is plumb and square. See "Minimum
Cutout Dimensions" in "Minimum Dimensions" section.
• Cutout floor that is solid, level and flush with bottom of
cabinet cutout.
• Support for weight of at least 150 Ibs (68 kg), which includes
microwave oven and items placed inside.
• Grounded electrical outlet. See "Electrical Requirements"
section.
• Minimum installation clearances for installation location. See
"Minimum Dimensions" section.
We recommend:
• Complete enclosure around the recessed portion of the
microwave oven.
C
A. Side brackets (2)
B. Removable extension plates
(shaded piece, 2)
C. Side trim panels (2)
D. 1" T-IO screws (6)
I"®TORX is a registered trademark of Acument Intellectual Properties, LLC
2