Hot Water Connection - Bosch SHI66A Installation Instructions Manual

Engl sh
HOT WATER CONNECTION
,_WARNING: SCALD HAZARD -
Working on a charged hot water line
could result in serious injury, or death,
Do not attempt any work on the
dishwasher hot water supply plumb-
ing unti_ you are certain the hot water
supply is shutoff.
NOTE: Make certain that the correct 90 °
eDow fitting (not supplied) for the hot
water suppFy tine has been purchased
and installed on the dishwasher as
described in the Dishwasher Prepara-
tion section of this manuat.
The hot water suppFy line may be
connected to the dishwasher in one of
two ways:
1) With braided hose
2) With copper tubing
Braided Hose
Ensure that atl threaded connections
are sealed with teflon tape or pipe
thread compound.
Copper Tubing
CAUTION: Temperatures required for
soldering and sweating witl damage
the dishwasher's water inter valve. If
plumbing lines are to be soldered or
sweated, keep the heat source at Ieast
6 inches (152.4 mm) away from the
dishwasher's water inlet vatve.
If using a solder joint instead of a
compression fitting, be sure to make all
solder connections before connecting
the water line to the dishwasher.
Make certain there are no sharp
bends or kinks in the water Iine that
might restrict water flow.
, When connecting threaded pipe use
pipe thread compound or Teflon tape to
seal the connection.
Before connecting the copper hot
water suppty line to the dishwasher,
flush it with hot water to clear any
foreign material.
, Turn on the water suppty to check for
leaks after making connections.
24 Hot Water Connection I Connexion eau Chaude [ Conexi6n de Agua Caliente