Placing The Dishwasher - Bosch SHI66A Installation Instructions Manual

G
Placing the Dishwasher
The profile strips on the sides of the
dishwasher allow the dishwasher to fit into
a cabinet opening with a width of 23-5/8"
(600 mm) to 244[/8" (613 mm). Before
sliding the dishwasher into the cabinet
opening:
• Straighten the hot water supply line and
the electrical cable (see Figure 11).
• Level & Align (initial adjustments).
• Guide the drain hose carefully (avoiding
kinks in hose) as the dishwasher is slid
into the cabinet opening.
• Make final leveling adjustments (see
FINAL STEPS Section).
• To maintain the dishwasher position and
alignment, first determine which type
of mounting your dishwasher needs:
Top Mount is used for all types of
countertops that will not be damaged
by drilling.
• For a top mount, position the
brackets fiat on each of the top
corners of the dishwasher as
shown in Figure 10A.
Side Mount is used when there is a
granite, marble or other hard natural
surface counter top that could be
damaged by drilling.
• For a side mount, bend the
brackets, then position them as
shown in Figure 10B.
• Drive Mounting Screws (see Figure 3)
through the holes in the brackets. See
Figure 10A or 10B.
• Connect the drain hose, hot water
supply line and electrical connections
as described in the following sections.
A, Mounting bracket
for mounting to under
A
countertop
Figure 10
Bo Mounting bracket
bent for mounting to
side of cabinets
IMPORTANT
]If you wish to change the front panel of
the dishwasher this must be done before
sliding the dishwasher into place.
_Note: Additional accessory door pa-
nels can not be used with SHU 9900
models.
Figure 11
8- ENGLTSH www.boschappliances,com