Placing The Dishwasher - Bosch SHU43E Installation Instructions Manual

PLACING THE DISHWASHER

Placing the Dishwasher
The profile strips on the sides of the
dishwasher allow the dishwasher to fit into
a cabinet opening with a width of 23-5/8"
(600 mm) to 24-1/8" (613 mm). Before
sliding the dishwasher into the cabinet
opening:
• Straighten the hot water supply line and
the electrical cable (see Figure 11).
• Level & Align (initial adjustments).
• Guide the drain hose carefully (avoiding
kinks in hose) as the dishwasher is slid
into the cabinet opening.
• Make final leveling adjustments (see
FINAL STEPS Section).
• To maintain the dishwasher position and
alignment, first determine which type
of mounting your dishwasher needs:
Top Mount is used for all types of
countertops that will not be damaged
by drilling.
• For a top mount, position the
brackets flat on each of the top
corners of the dishwasher as
shown in Figure 10A.
Side Mount is used when there is a
granite, marble or other hard natural
surface counter top that could be
damaged by drilling.
• For a side mount, bend the
brackets, then position them as
shown in Figure 10B.
• Drive Mounting Screws (see Figure 3)
through the holes in the brackets. See
Figure 10A or 10B.
• Connect the drain hose, hot water
supply line and electrical connections
as described in the following sections.
8 - ENGLISH
A. Mounting bracket
for mounting to under
countertop
Figure 10
If you wish to change the front panel of
the dishwasher this must be done before
sliding the dishwasher into place.
*Note: Additional accessory door pa-
nels can not be used with SHU 9900
models.
Figure 11
www.boschappliances.com
B. Mounting bracket
bent for mounting to
side of cabinets
IMPORTANT