Connect Gas Supply Pipe - Amana LED20AW-PLED20AW Installation Instructions Manual

STEP 3: (Gas Dryer ONLY)
Connect Gas Supply Pipe
For further assistance, refer to Section on Gas Requirements
1. Make certain your dryer is
equipped fc)r use with the type
of gas in your laundry room.
Dryer is equipped at the factory
for Natural Gas with a 3/8" (9.5
mm) NPT gas connection.
2. Remove the shipping cap from
the gas connection at the rear of
the dryer. Make sure you do not
damage the pipe threads when
removing the cap.
3. Connect to gas supply pipe.
4. Tighten all connections;
securely. Turn on gas and check
all pipe connections (internal &
external) for gas leaks with a
non-cocrosive leak detection
fluid.
5. For L.P. gas connection,, refer to
Section on Gas Requirements.
NEW METAL
FLEXIBLE
CONNECTOR
USE ONLY
IF ALLOWED
BY LOCAL
CODES
(Use
Design A.G.A.
Certified
Connector)
3/8" (9.5 mm) NPT
GAS CONNECTION
BLACK IRON PIPE
Shorter than 20' (6.1 rn) - use 3/8" pipe
Longer than 20' (6.1 m) - use 1/2" pipe
1/8" NPT
PIPE PLUG
(For checking
inlet gas pressure)
/
jr
EQUIPMENT
SHUT-OFF
.__....._/- VALVE
Install within
(i' (1.8 rn) of dryer
D2331E3D
6 503953