Amana LED20AW-PLED20AW Installation Instructions Manual page 11

Home laundry automatic dryers (electric and gas models)
Table of Contents

Advertisement

Manufactured
(Mobile)
Home
Installation...
IMPORTANT:
Installation
must conform
to
"_
the Manufactured
Home Construction
and
|
Safety Standards,
Title 24 CFR, Part 32-80 or l
andard CAN/CSA-Z240
MH__p...J
The dryer can be installed
in a
manufactured
(mobile) home by
following
these instructions:
1. IMPORTANT:
Gas dryers
MUST
be permanently
attached
to the floor at the
time of installation.
Order No.
526P3 Dryer Installation
Kit
for a manufactured
(mobile)
home installation.
Follow
the
instructions
supplied
with the
kit.
2. Electrical
Connections
(Electric
Dryer Only) must be a 4-wire
connection,
refer to page 13.
3. Venting--Dryer
MUST be
exhausted
to the outdoors.
WARNING
To reduce the risk of fire and
combustion
gas
accumulation,
the dryer
MUST
BE EXHAUSTED
TO
THE OUTDOORS.
Refer to
Section
on Dryer Exhaust
Requirements.
W047
The dryer can be exhausted
to the
outdoors
through the back, left,
right or bottom panel. Gas dryers
cannot be exhausted
out the left
side because of the burner
housing.
The dryer exhaust duct must be:
secured to the mobile home
structure.
Exhaust ducts MUST NOT be
connected
with sheet metal
screws or fasteners
which extend
into the duct.
Exhaust duct must not be
connected
to any other duct, vent
or chimney.
Dryer exhaust
duct MUST NO-['
terminate
under the mobile home.
For proper operation,
it is
important
that tile dryer has an
ample amount of outside make-
up air. The free area of any
opening for the introduction
ot
outside air must be at least 25 in 2
( 163 cm2).
• When exhausting
the, dryer to the
outdoors, the dryer can be
installed with "0" inch clearance
a! the sides and rear. Clearance
of
the du =t from combustible
constraction
must be a minimum
of 2 irlches (5.08 cm).
• Venting materials
are not
supplied with the dryer (obtain
locally).
WARNING
To reduce the risk of fire, the
exhaust
duct and weather
hood MUST be fabricated
of
a material
that will not
support
combustion.
Rigid
or flex ible metal pipe is
reconl mended
for a clothes
dryer.
W048
503953
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents