Table of Contents
Advertisement
USR4204. See
and Password
See
FAQs and Troubleshooting
Config Security Menu (Main Menu
Configure Security Menu
CMD
'0' Select
"Admin Username
'1' Select
"
'2' Select
"
'3' Select
"
'4' Select
"
'5' Select
"
'6' Select
"
'7' Select
"
'-' Return
to Config Parameters Menu
At the top of the Configure Security Menu is the menu name. A list of valid commands, text,
and status follows. Invalid commands are ignored.
Use a Select command (see below) to set up the Administrator and up to 15 User accounts.
'0' Select Admin
Navigate to the Administrator Menu with this command. It is the only command available if
security is off. Use this command to setup the Administrator account and turn on security.
'1'–'9' and 'A'–'F' Select User
Navigate to the corresponding User Menu with this command. The current User status
(ON/OFF) is shown in parentheses next to the User name. Use this command to setup a
User account.
NOTE: To re-enable a disabled or locked out user, select the user then Toggle
the User Enable status to 'ON'.
USR4204 User Guide
"
Clearing A Forgotten or Disabled Administrator Name
"
for details.
for suggested security guidelines.
Y
(current enabled state in parentheses below)
" Admin
" (OFF)
" (OFF)
" (OFF)
" (OFF)
" (OFF)
" (OFF)
" (OFF)
Page 27 of 52
U)
CMD
'8' Select
"
'9' Select
"
'A' Select
"
'B' Select
"
'C' Select
"
'D' Select
"
'E' Select
"
'F' Select
"User 15
'&' Remove ALL Accounts
" (OFF)
" (OFF)
" (OFF)
" (OFF)
" (OFF)
" (OFF)
" (OFF)
" (ON )
Advertisement
Table of Contents
