Table of Contents
Advertisement
Configure Parameters Menu (Main Menu
T/O Esc Menu Xon Xoff Flow Pass Echo AutoCR DCD Banr
005
-
-
^Q
----------------------------------------------------
Configure Parameters Menu
CMD
'T' Change
Inactivity Timeout
'S' Change
Char for Escape
'N' Change
Char for Xon
'W' Enter
Login Banner
'F' Toggle
S/W Flow Control
'E' Toggle
Command Echo
'D' Toggle
DCD Override
'U' Config
Security
'-' Return
to MAIN Menu
At the top of the Configure Parameters Menu is a banner that displays the current system
parameters. Directly below the banner are the menu name, the user-programmable device
name, the firmware version number and date, and the serial number of the USR4204. Below
that is a list of valid commands and text. Invalid commands are ignored.
'T' Change Inactivity Timeout
The USR4204 will close a serial port if no data passes in or out of the terminal or serial port
before this inactivity time lapses. If security is enabled, the session will also logout.
Valid range: 0 to 255 minutes (0 disables the timer)
Default: 005
'R' Rename
Rename the USR4204 with this command. It navigates to the Rename screen. The USR4204
name may be up to 32 (displayable) characters in length.
Default: USR4204
'S' Change Char for Escape
Change the Escape Sequence character with this command. It navigates to the Change
Character screen.
The Escape Sequence may be disabled by programming this character to a control-\. To
enter control-\ in the Change Character screen, hold down the Ctrl key and press \
USR4204 User Guide
^S
OFF
OFF
ON
Ver 1.12 09/18/13
Page 23 of 52
Y)
ON
OFF
OFF
S/N: 1ME4Z7PM0004
CMD
'R' Rename
System
'M' Change
Char for Menu
'X' Change
Char for Xoff
'Y' Enter
Security Banner
'P' Toggle
Xon/Xoff Pass Thru
'A' Toggle
Auto CR
'B' Toggle
Security Banner
'&' Load
Factory Parameters
'!' Flash
New Code
Advertisement
Table of Contents
