Outdoor Installation; Battery Information - JabloCom EYE-02 User Manual

5.8 E������� W������� D������
The EYE-02 camera has a built-in short range radio transceiver, which allows communication with a wide range of
professional security wireless devices from OASiS system produced by JABLOTRON ALARMS (see www.jablotron.com).
This is a very simple way to extend your camera function to provide additional services such as:
• heating control by a mobile phone
• PANIC button function for elderly or disabled people.
Refer to the table on the inside back cover page of this manual for a brief review of available types of wireless devices.
For enrolling a new device use JabloTool software (EYE-02/Configuration/External devices/Add new device) or switch the
camera to the ENROLL mode.
For installing all wireless components follow their manual.
• Remote controls / panic buttons: switch the camera to the ENROLL mode, press any button on the remote control.
• Detectors: switch the camera to the ENROLL mode, insert the battery in to the detector.
• JA-80L Siren: switch the camera to the ENROLL mode, plug the siren to the wall socket.
• JA-80A Siren: switch the camera to the ENROLL mode, connect the battery in the siren socket.
• AC-82 Wireless relay: switch the camera to the ENROLL mode, follow the manual of AC-82. For activating the
transmitter of EYE-02 press the power button on the camera shortly.
Once the camera is enrolled into the wireless relay, you can choose function of the relay outputs. Outputs can be
managed by an SMS, can signal the mode of camera, etc. For settings go to JabloTool EYE-02/Configuration/External
devices/ Programmable outputs.
For more information about wireless devices see application notes on www.jablocom.com
5.9 O������ I�����������
Although the EYE-02 camera housing provides a basic humidity resistance, it is required to use an additional plastic
housing when mounted outdoors to protect the camera against rain and snow. If an external housing with a front glass is
used, the internal IR illumination must be switched off and an external IR lamp must be used.
Please visit the www.jablocom.com web page to see the detail application notes about outdoor installation or usage
with a solar power panel.
6. M����������
The EYE-02 camera doesn't require any special maintenance.
• Check the event reporting function by the REPORT command at least once a month.
• Regularly test the basic function of all detectors by the TEST mode.
• Regularly test the battery of the remote control by pressing any button. If the light on your remote does not switch
on, the battery is discharged and should be replaced. Replace the battery with a new one of same or equivalent
type.
2
• Once a year, check the camera's battery capacity – see chapter 8.1 Battery information.
JR_EYE-02.ENG.MAN.Manual.19.C-2A
1
Remote control - battery replace procedure
1
- 17 -
2
EN