Arpeggio Settings; Arpeggio Function - Oberheim OB 12 Operating Manual

OB 12
SELECTIONS
FILT.RES.
resonance of FILTERS
FILT.ATTACK
FILT.DECAY
FILT.SUST.
FILT.REL.
FILT.ENV.DP
FILT.LFO1DP
AMPL.ATTACK
AMPLIFIER envelope
AMPL.DECAY
AMPLIFIER envelope
AMPL.SUST.
AMPLIFIER envelope
By selecting the PEDAL2 folder you can assign the function of choice to the pedal connected to
the rear PEDAL [EXP.2] connector. The video page will be identical to that relating to the PEDAL1
setting.
The ARPEGGIO function allows arpeggios to be performed by playing a chord on the keyboard or
pressing just one note and creating octave arpeggios on it.
The HOLD function (activated using the button of the same name in this section) allows you to play
arpeggios even after the keyboard notes have been released. Notes played subsequently will
replace the previous ones with the arpeggio mode active.
You can therefore use regular arpeggios, by selecting the beat required, or irregular arpeggios, for
which there are a choice of Patterns.
This section of the Program environment allows you to set the modes, the range in octaves and
the tempo of the arpeggio, and the keyboard section and Parts affected by the function.
This section is independent of the PART SETTINGS: the arpeggio notes will be performed with the
Timbres present in the Parts enabled for the function.
From the EDIT PROGRAM MENU select field 6-ARPEGGIO. The display will show the first video
page relating to the settings of this function:
the parameters this video page contains are the following:
STATUS
(Arpeggio Status, [ON/OFF] in the ARPEGGIO section)

Arpeggio function.

CONTROLLED CONTROLS ON
PARAMETERS PANEL
[RESONANCE] of
FILTERS
attack time of the
[ATTACK] of FILTERS
FILTERS envelope
decay time of the
[DECAY] of FILTERS
FILTERS envelope
sustain level of the
[SUSTAIN] of FILTERS
FILTERS envelope
release time of the [RELEASE] of
FILTERS envelope FILTERS
FILTERS envelope [ENV DEPTH] of
depth FILTERS
modulation depth of [LFO1 DEPTH] of
LFO1 on OSC.1 FILTERS
attack time of the [ATTACK] of
AMPLIFIER
decay time of the [DECAY] of
AMPLIFIER
sustain level of the [SUSTAIN] of
AMPLIFIER
CONTROLLED
SELECTIONS
PARAMETERS
release time of the
AMPL.REL.
AMPLIFIER envelope
AMPL.AMOUNT
Timbre level
modulation depth of
AMPL.LFO1DP
LFO1 on AMPLIFIER
LFO2 RATE
LFO2 signal frequency
modulation depth of
LFO2 DP.OS1
LFO2 on OSC.1
modulation depth of
LFO2 DP.OS2
LFO2 on OSC.2
modulation depth of
LFO2 DP.FLT
LFO2 on FILTERS
modulation depth of
LFO2 DP.AMP
LFO2 on AMPLIFIER
PORTAM.TIME
Portamento time
: activates (ON) or disables (OFF) the
204
CONTROLS ON
PANEL
[RELEASE] of
AMPLIFIER
[AMOUNT] of
AMPLIFIER
[LFO1 DEPTH] of
AMPLIFIER
[RATE] of LFO2
[MODULATION]
[MODULATION]
[MODULATION]
[MODULATION]
[TIME] of
PORTAMENTO