Routing Configuration; Edit Effects - Oberheim OB 12 Operating Manual

algorithms within the effects chain. As already described in 9.2 – Bus Settings, thanks to this
function you can associate the effect of your choice to one or more Timbres, in order to set the
configurations best suited to the sound required.
We will therefore now see how to proceed with configuration of the EFFECTS section.
From the EDIT PROGRAM MENU select field 3-EFFECTS; the display will show the page enabled
for selection of the effects section the user wishes to display.
containing two selection fields:
1-ROUTING CONFIGURATION: section relating to the configuration and positioning of the
algorithms within the output buses.
2-EFFECT SETTINGS: section enabled for programming of the effects.
From the EDIT EFFECT video page just described, select field 1-ROUTING CONFIGURATION.
The display will show:
in which we can see a graph (on the left of the screen) showing the configuration and position of
the algorithms, and then the parameters:
ROUTER: sets the configuration of the algorithms in the effects chain.
EFX CONF
(Effect Configuration)
selected.
Once the effect positioning operations have been carried out, you can display the OUT COUPLER
video page to set up the outputs. This allows you to assign the four buses which you have configured
to the four (MAIN [L/Mono], [R] e AUX OUT [1] and [2]) outputs, or exclusively to the MAIN outputs
(if these are the only outputs used). Press button [F2] to select the OUT ROUTE folder and the
display will show:
You can use the AUX MODE parameter to decide whether to use the output ports in standard
mode, by setting AUX MODE as STANDARD, or to address the AUX [1] and [2] ports to the MAIN
[L-Mono] and [R], by setting AUX MODE as COUPLED.
: establishes the position of the effects in relation to the Router
195
OB 12