Tank Assembly - Culligan HE Owner's Manual

High efficiency automatic water softener
Table of Contents

Advertisement

01021076
12
Drain Facilities
Choose a nearby drain that can handle the rated drain flow (floor drain, sink or stand pipe). Refer to
"Table 3. Height of Discharge Above Floor Level Operating." on page 22, for maximum drain line length.
NOTE
Most codes require an anti-siphon device or air gap. Observe all local
plumbing codes and drain restrictions. The system and installation must
comply with all state and local laws and regulations.
Electrical Facilities
A 10-foot cord and wall mount plug-in transformer are provided. The customer should provide a recepta-
cle, preferably one not controlled by a switch that can be turned off accidentally. Observe local electrical
codes.
NOTE
The softener works on 24 Volt/60 Hz electrical power only. Be sure to use the
included transformer. Be sure the electrical outlet and transformer are in an
inside location to protect from moisture. Properly ground to conform with all
governing codes and ordinances.
NOTE
PN 01020620 and PN 01018133 plug-in transformer are rated for indoor
installations only.
Placement
NOTE
Read this section entirely before starting the installation. Follow all applicable
plumbing and electrical codes.
Refer to Figure 1 for system placement.
1.
With the exception of media containers, open the remaining containers, remove all the compo-
nents, and inspect them before starting installation.
2.
Set the media tank on a solid, level surface near water, drain and electrical facilities.
3.
Set the brine system on a flat, smooth, solid surface as near the media tank as possible.

Tank Assembly

9" and 10" tanks are filled with media at the factory.
1.
Before the unit can be connected to the plumbing, you must insert the manifold and load the
media into the tank for 12" and 14" units.
CAUTION! Do not lay the tank down unless a suitable lifting device
Position the Mineral Tank(s)
Determine the location for the mineral tanks(s) prior to loading, because they will be difficult to move after
the underbedding and gravel are loaded.
is available. Personal injury and damage to the unit can
result if dropped.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

He series

Table of Contents