Control Panel; Accessing The Inside Of The System - Supero SUPERSERVER 8017R-TF+ User Manual

S S
UPER ERVER 8017R-TF+/8017R-7FT+ User's Manual
Figure 6-1. Chassis: Front and Rear Views
Power Supply Module
I/O Ports (see Chapter 5)
6-2

Control Panel

The control panel (located on the front of the chassis) must be connected to the JF1
connector on the serverboard to provide you with system status indications. These
wires have been bundled together as a ribbon cable to simplify the connection.
Connect the cable from JF1 on the serverboard to the appropriate header on the
Control Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1
on both connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System In-
terface" for details on the LEDs and the control panel buttons. Details on JF1 can
be found in "Chapter 5: Advanced Serverboard Setup."
6-3

Accessing the Inside of the System

You may need to access the inside of the server to perform some maintenance,
such as relacing fans.
1. First, release the retention screws that secure the system to the rack.
2. Grasp the two handles on either side and pull the system straight out until it
locks (you will hear a "click").
Slim DVD-ROM Drive
SATA Drive Bays
PCI Expansion Slot (w/ riser card)
6-2
Control Panel