Advertisement
Available languages
Available languages
To Convert Surface
Burners
1. If installed, remove the burner grates.
2. Remove the burner caps.
3. Using a Phillips screwdriver, remove the burner base.
................................
\
A. Burner cap
B. Gas tube opening
C. Burner base screws
D. Burner base
4=
Apply masking tape to the end of a %2" (7 mm) nut driver to
help hold the Natural gas orifice spud in the nut driver while
changing it. Press nut driver down onto the Natural gas orifice
spud and remove by turning it counterclockwise
and lifting
out. Set Natural gas orifice spud aside.
A
A. Natural gas orifice spud
Use the following chart for correct LP gas orifice spud for each
burner. Refer to the gas information plate on the right-hand side of
the bottom oven frame for proper sizing of LP gas orifice spuds
for each burner location.
LP Gas Orifice Spud Chart
Location
Burner Rating
Color
Number
Right Front
14,000 BTU
Red
114L
Right Rear
4,000 BTU
Blue
64L
Left Front
8,000 BTU
Clear
35L
Left Rear
8,000 BTU
Clear
35L
5. Replace the Natural gas orifice spud with the correct LP gas
orifice spud. See the "LP Gas Orifice Spud Chart."
6. Replace burner base and hand tighten the screws.
7. Replace burner cap.
8. Repeat steps 1 through 7 for the remaining burners.
9. Place Natural gas orifice spuds in plastic parts bag for future
use and keep with package containing literature.
10. Replace burner grates.
11. Plug in range or reconnect power.
12. Complete installation. See "Make Gas Connection"
and
"Electronic Ignition System" sections.
Checking for proper cooktop burner flame is very important.
The small inner cone should have a very distinct blue flame 1¼,,
to 1/2"long. The outer cone is not as distinct as the inner cone.
LP gas flames have a slightly yellow tip.
IMPORTANT: You may have to adjust the "LO" setting for
each cooktop burner.
_(i_
%, (_
_'
_'_
'"
'*_ _S
°'
(_i_ii_'d*_lY_t_;_/(_)_
__''_' _ '_...........
'_ *_
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti=tip bracket to rear range foot.
Reconnect
the anti=tip bracket,
if the range is moved.
Failure to follow these instructions can result in death
or serious
burns to children
and adults.
1=
2.
Turn manual shutoff valve to the closed position.
Unplug range or disconnect power.
...................
B
A
........................
C
A. To range
B. Shutoff valve (closed position)
C. Gas supply line
23
Advertisement
