Troubleshooting - Haier hlp140e User Manual

Trouble Shooting
(If problems occur, please pull out the plug to check)Before calling out a Service engineer have
a quick look through the following fault list- it could have save a lot of time and trouble. If your
machine is still not working properly you should contact your nearest Service office or obtain
after sales service quickly. Please do not fix the machine by yourself.
SYMPTOM
No power to machine
Is the plug properly put in the
socket?
Is the front door properly shut?
Dryer won't heat.
Has the Power/ ON/OFF, or
Start/Pause button been
pressed in?
Is the Temperature button Indicator
light indicating "Air Dry"?
Dryer won't heat. Is the clothes dryer working?
Is the outlet filter-net been
blocked?
Are the garments fully dehydrated?
Garments won't dry
Have you dried too many garments
enough. ( Not all the
in weight?
garments are dry
Is a garment filling occurs when the
enough after the
machine is working?
machine stops work)
Have the garments got tangled up?
Are the easy/hard dry clothes not
sorted?
Is the dryer standing position
narrow and stuffy?
Drum won't turn.
Close the front door.
(The three indicator
lights of Cycle
button are on at the
same time)
Drum won't turn.
You may have chosen the "Auto-Dry"
(The "150", " 90",
mode of drying if the garments are
"60" indicator lights
not dried over 5 hours .
of Drying Time
( Referring to symptom 3)
button are on at the
same time)
CAUSE
CURE
Reset circuit breaker; use the
machine when there is power.
Check and tighten plug.
Close the front door.
Press in the Power/ ON/OFF,
or Start/Pause button.
Reset the "Temp" button till the
indicator light indicates "High"
or "Low", and the light is on.
This is probably as a result of
the heat been absorbed by the
wet clothes for a while when
starting the machine, after 30
minutes it will be normal.
Rinse the filter-net clear.
Got the garments fully
dehydrated.
Reduce the garments amount.
Select out the garments that
not dry to make them dried.
Separate the tangled-up
garments and make them dried.
Select out the garments that
not dry to make them dried.
Place the machine in a position
that ventilate well.
Press in the Start/Pause
button.
After troubleshoot problem 3,
press in the Power/ ON/OFF,
or Start/Pause button.