Advertisement
9.
Replace Kick Panel, Storage Drawer or
Warmer Drawer:
(instructions for warmer drawer)
a. Pullthe bearingglidesto the front of the
chassis
glide (see picture below).
b. Align the glide on each side ofthe drawer with the glide
slots on the range.
c.
Push the drawer
into the range until levers "click"
(approximately 2"). Pull the drawer open again to seat
bearing glides into position.
If you do not hear the
levers "click'"
or the bearing
glides do not feel
seated
remove
the drawer and repeat
steps "a"
through
"c". This will minimize possible damage to the
bearing glides,
FIGURE 13
CONVERSION
TO NATURAL
GAS
If it becomes necessary to convert the range back to natural
gas:
a.
Disconnect
gas and electrical
supply
from
range.
b.
Convert
pressure regulator,
turn cap over so the solid end of
cap faces outward.
Place the hollow
end of the cap into the
loop end of the dust protector.
(See step 1.)
c.
Replace .89 mm orifices in the top burners with original
1.60
mm orifices. Remove the LP/Propane restrictor
in the cavity
directly
opposite
the electrode.
Replace screw previously
holding restrictor in place.
Do not over tighten.
Remove the
choke.
Replace screw previously
holding choke in place.
Do
not over tighten.
(See step 2.)
d.
Convert
Oven Burner
Orifice
for
Natural
Gas by loosening
spud
counter-clockwise
(approximately
2-1/2
turns).
(See
step 3.)
e.
Convert
Waist-High
Broiler
Burner
Orifice
(Self-Cleaning
Models
On_y) for
Natural
Gas by loosening
spud
counter-
clockwise
(approximately
2-1/2 turns).
(See step 4.)
f.
Readjust "LOW"
Setting
for Surface
Burner Valves following
instructions.
(See step 6.)
g.
Readjust
Oven & Broil Burner Air Shutters.
(See steps 7 & 8.)
6
Advertisement
