Advertisement
How
to Convert
the Range for use
with LP/Propane Gas
1. Convert the Pressure Regulator
To access the regulator,remove
the kick panel, storage
drawer
or warmer
drawer.
If equipped
with
a broiler
drawer,
open drawer
completely.
For models
equipped
with
warmer
drawer,
follow
the
instructions
below
to
remove warmer
drawer,
a.
_|Nkvivl_.l_t_ll_[C'tl Electrical
Shock Hazard can occur and
result in serious injury or death.
Disconnect
electrical
power
to the
range
before
removing
the
warmer
drawer
for servicing.
b.
Open the drawer
to the fully opened
position.
c.
Locate glide lever on each side of drawer, pull up on the
left glide lever and push down
on the right
glide lever
(see figure
1).
d.
Pull the drawer
away from the range.
Pull up with finger
[]
@@
@
@@
II
II
Front Access
to Regulator:
Remove Kick Panel,
StorageDrawer,
or
Warmer Drawer,
(See Owner's Guide
for Instructions).
If Equipped with
Broiler Drawer.
Open Broiler Drawer.
Pressure
Regulator
location
at
rear of
range
Left Glide
Right Glide
.... _ er
p__
L[]
FIGURE 1
FIGURE 2
e.
Do not remove the Pressure Regulator
or allow it to
rotate
or turn.
Remove the dust protector from the
cap,
Using a 5/8" wrench,
unscrew
the cap from the
pressure regulator.
Do not remove
the spring
from
the regulator.
Do not pull on spring.
f.
Turn the cap over so the hollow
end faces outward.
Place the solid end of the cap into the loop end of the
dust protector
as shown
in illustration
below.
g.
Replace the cap on the regulator.
The letters LP should
be visible on the exposed end of the cap. Snap the dust
protector
over the regulator
cap.
Dust
Protector
Spring
i_
FIGURE 3
Hollow End
Solid End
Towards
Towards
Regulator
Regulator
for Natural
Gas
for LP/Propane Gas
Advertisement
