AUSTRALIAN MONITOR AMC+30 Installation And Operation Manual
Amc+ series mixer amplifiers
Hide thumbs
Also See for AMC+30:
- Installation and operation manual (13 pages) ,
- Installation and operation manual (36 pages)
Related Manuals for AUSTRALIAN MONITOR AMC+30
Summary of Contents for AUSTRALIAN MONITOR AMC+30
- Page 1 INSTALLATION AND OPERATION MANUAL AMC+ SERIES MIXER AMPLIFIERS AMC+30 AMC+60 AMC+120 AMC+250...
-
Page 2: Important Safety Information
à la pluie ou à l’humidité. 20. AMC+30 - Risk of hazardous energy. Class 2 wiring should be used. 19. Un appareil avec la borne de terre de protection doit être connecté au 21. - Page 3 INTRODUCTION AND CONTENTS AMC+ SERIES INTRODUCTION The Australian Monitor AMC series of amplifiers takes the heritage FRONT PANEL and reliability of our famous AMIS series amplifiers and integrates these features into low cost amplifiers for applications where REAR PANEL reliability is everything, but the more elaborate features of our AMIS series are not required.
-
Page 4: Front Panel
Power This switch switches power on or off the mains. The up position is on. NOTE: For the model AMC+30 For the model AMC+60, AMC+120, AMC+250 Risk of hazardous energy. Class 2 wiring should be used. The apparatus Risk of hazardous voltage. Class 3 wiring should be used. The... -
Page 5: Rear Panel
The operating voltage of the amplifier is user selectable between for 115V or 230V operation via a slide switch These terminals are for use with an optional tone module (not supplied). Use Australian Monitor located above the AC mains inlet. This switch should be set to ATC5488 module. -
Page 6: Installation
INSTALLATION NOTE: Only connect one output – either Distributed Line or Low Impedance REMARQUE: Ne branchez une sortie - soit en ligne ou distribués basse impédance Mounting Montage Your amplifier is designed for standard 19” rack mounting and occupies 2 EIA rackunits (3.5”). -
Page 7: Direct Output
INSTALLATION Direct Output The output terminal strip accepts wire sizes from 16-22AWG (1.5mm2 – 0.35mm2) or spade lugs. The following table should be used as a guideline for cable sizes. Regulations in your area may require different gauged wire and should be checked before using. OUTPUT DISTANCE WIRE SIZE... -
Page 8: Troubleshooting Guide
120 AMC 250 only) Make sure the amplifier is well ventilated DC fuse(s) blown Refer product to local Australian Monitor dealer Remove signal (disconnect input) from channel 1 OR No sound from channels 2 and 3 Priority function is being used... -
Page 9: Block Diagram
BLOCK DIAGRAM SERIES INSTALLATION AND OPERATION MANUAL PAGE 9... -
Page 10: Functional Notes And Internal Adjustments
FUNCTIONAL NOTES AND INTERNAL ADJUSTMENTS Priority Channel 1 will mute channels 2, 3 and 4. This will only occur when signal appears on channel 1, irrespective of the channel volume control. Priority can be disabled. (See below). The release time is approx. 3 secs and is NOT adjustable. The mute depth is approx. - Page 11 DIMENSIONS DIRECT OUT CLASS 2 WIRING LINE TONE MODULE AMC+ 120 Audio Amplifier Model: AMC+120 Rated Value: CONFORMS TO 115V~60Hz 460W ANSI/UL SYD.60065 230V~ 50Hz 460W CERTIFIED TO Manufacture Date: CAN/CSA STD.C22.2 Made In China No.60065 115 V. FUSE T4AH 250V 230 V.
-
Page 12: Specifications
SPECIFICATIONS Power Output (0.5%Thd, 1khz) 120W 250W S/N Ratio > 75dBr > 75dBr > 80dBr >85dBr Power Bandwidth (-3db +1db) 85Hz-18kHz 75Hz-20kHz 70Hz-20kHz 40Hz-20kHz Fuses MAINS (115V) 1.0A 3.15A MAINS (230) 0.5A 1.6A 1.6A (x2) 10A (x2) Output Regulation Size (Wxhxd) 482 x 88 x 190mm 482 x 88 x 281mm 482 x 88 x 281mm... -
Page 13: Common To All Models
SPECIFICATIONS COMMON TO ALL MODELS Thd (1khz, -1db) Better than 0.5% Mic Input SENSITIVITY 1mV @ 200ohm IMPEDANCE 1k3 ohm HEADROOM 77mV (37dB) Aux Input SENSITIVITY 150mV IMPEDANCE >200kohm HEADROOM > 15V (>40dB) Tone Control BASS @ 100HZ +/- 12 dB TREBLE @ 10KHZ +/- 9 dB Line Out... - Page 14 NOTES PAGE 14 SERIES INSTALLATION AND OPERATION MANUAL...
- Page 15 NOTES SERIES INSTALLATION AND OPERATION MANUAL PAGE 15...
- Page 16 ENGINEERED BY AUSTRALIAN MONITOR Address: 1 Clyde Street, Silverwater, Sydney NSW 2128 Australia. Private Bag 149, Silverwater NSW 1811 ABN 78 001 345 482 Website: www.australianmonitor.com.au International enquiries email: international@australianmonitor.com.au DISTRIBUTED IN AUSTRALIA AND NEW ZEALAND BY HILLS SVL www.hillssvl.com.au...
Need help?
Do you have a question about the AMC+30 and is the answer not in the manual?
Questions and answers