Complete Installation; Check Operation - Kenmore 66514219K901 Installation Instructions Manual

Complete installation
1. Check that grounding clip is attached to the access
panel.
2. Start the screws in the lower panel holes on the
dishwasher. Do not tighten.
3. Place the lower panel behind the access panel.
i
clip _.
4. Slide the lower panel over and down onto the screws.
5. Hold the 2 panels together and place them against the
dishwasher leg.
6. Reattach the access panel to the dishwasher.
7. Reinstall the screws through the holes in the access
panel and the slots in the lower panel. Install the right
side screw first.
8. Check that the lower edge of the lower panel contacts
the floor.
9. Tighten the screws.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result
in death, fire, or electrical shock.
10. Reconnect power or plug in dishwasher.
Check operation
1. Read the Use and Care Guide that came with your
dishwasher.
2. Check that all parts have been installed and no steps
were skipped.
3. Check that you have all the tools you used.
4. Start dishwasher and allow it to complete the shortest
wash cycle. After the first 2 minutes, unlatch door, wait
5 seconds, then open door.
5. Check to see that there is water in the bottom of the
dishwasher tub. Check that dishwasher is working
properly.
6. If not, disconnect power or unplug dishwasher and see
"If dishwasher does not operate" section.
if dishwasher does not operate
First try the solutions suggested here to possibly avoid the
cost of a service call.
Has the circuit breaker tripped or the house fuse blown?
Is the door closed tightly and latched?
Has the cycle been set correctly to start the dishwasher?
Is the water turned on?
If none of these work, call 1-800-4MY-HOME.
14