Haier CGDE700AW User Manual page 19

4. Press "Temp" button to set a suitable drying temperature.
• After switching on, the dryer sets corresponding temperature adapting to
different program selected. If other drying temperature is wanted, press "Temp"
button to enable such a selection.
5. Press "Signal" button, a buzzer will sound upon end of a cycle.
• After switching on, the dryer automatically sets buzzer at "Softer", while the
user may define three prompt sound conditions "Louder", "Softer" and "Off".
6. Press "Wrinkle Saver"button to select a suitable reserved drying program.
• After powering on, the dryer delay start drying program automatically sets
as disabled. When you desire a drying cycle after a delay time, press
"Wrinkle Saver" button to set wrinkle saver drying program. After initial
pressing, the LED display indicates 3 hrs, which will be increased until 24 hrs
by an increment 1 hr with every pressing. Press again will display drying time.
Here if press again, it will repeat from 3 hrs. If keep pressed for 1.5 seconds,
LED display will increase continuously.
• When "Wrinkle Saver" is enabled, your selected program indicator turns off
while "Wrinkle Saver"indicator and remaining reservation time indication turn
on. During reserved period, pressing "Wrinkle Saver" button can indicate
reserve status.
• To change operating program or cancel delay, you should press "OFF" and
re-select a new cycle.
7. Press "Touch Up" button to select wrinkle-proof drying mode.
• Use the "Touch Up" cycle to continue drying if clothes are still damp after the
Automatic cycle.
• You can also use the "Touch Up" cycle to remove wrinkles from clean
clothes which packed tightly in a suitcase or closet.
8. Press "Start/Pause" button
• When starting the machine, first close the door and then press this
button.
• If pause is needed during machine operating, press this button. Pressing
again will resume operation.
Français
18