Appendix Ii Installing A Standalone Unit - Foxcom Sat-Light 7410F Installation And User Manual

7410F IFL Installation and User's Guide
6.2.2. Compressed Air Method
Using the extension tube of the compressed air, blow into the port to
remove any dust or debris. Do not allow the tube to touch the bottom
of the port. Do not use commercial compressed air due to potential oil
contamination.
Note
To prevent contamination, the optical ports should be connected or
covered with a dust cap at all times.
Use dry air or nitrogen only.

7. Appendix II Installing a Standalone Unit

To install the 7410FT or 7410FR Standalone:
1. Place the 7410F unit on the standalone flange, matching the holes.
2. Using four screws (#4 or #6) secure the unit and the flange to the wall.
3. Apply AC power to the standalone power supply unit.
4. Connect the 7410F unit to the power supply. The Laser LED should be lit.
5. All remaining steps are the same as in the product manual. Refer to Setting Up
the Transmitter on page 17, and Setting Up the Receiver on page 19.
Foxcom Proprietary Information
Appendix II Installing a Standalone Unit
Document No. 93-006-01-A
41