The 2300 Relay Adaptor; Figure 42 - Mounting The Chassis And Adaptor - Detail - Foxcom Sat-Light 7410F Installation And User Manual

7410F IFL Installation and Users Guide

9.6 The 2300 Relay Adaptor

The following section describes how to install the 2300 Relay Adaptor onto
the 7100M Chassis. The 2300 Relay Adaptor assembly provides dry contact
outputs as an option to the standard open collector signals available on the
7100M chassis backplane.
If the 2300 Relay Adaptor is ordered separately from the 7100M chassis, it
must mounted by the user. The 2300 is easily mounted directly over the
connectors on the 7100M backplane, as shown below.
9.6.1. Installing the 2300 - Parts Needed
•
2300 Relay Adapter
•
Two pin guides
•
Four one inch screws
•
Screw driver
9.6.2. Installing the 2300 - Procedure
To mount to the 2300 Relay Adapter:
WARNING
DO NOT PERFORM THIS PROCEDURE BEFORE
DISCONNECTING THE ELECTRICITY
1. Disconnect the electricity.
2. Make sure that you have all the needed equipment.
3. Install the pin guides.

Figure 42 - Mounting the Chassis and Adaptor - Detail

4. Mount the unit onto the pin guides.
Foxcom Proprietary Information
Document No. 93-006-01-A
Appendix IV 7100M Chassis
63