7410F IFL Installation and User's Guide
8. Appendix III The 2380 Relay Adaptor
The following section describes how to install the 2380 Relay Adaptor onto the
7180M Chassis. The 2380 Relay Adaptor assembly provides dry contact output
signals as an option to the standard open collector signals available on the 7180M
chassis backplane.
If the 2380 Relay Adaptor is ordered separately from the 7180M chassis, it must
mounted by the user. The 2380 is easily mounted directly over the connectors on
the 7180M backplane, as shown below.
8.1 Installing the 2380 - Parts Needed
• 2380 Relay Adapter
• Two pin guides
• Four one inch screws
• Screw driver
8.2 Installing the 2380 - Procedure
To mount to the 2380 Relay Adapter:
WARNING
DO NOT PERFORM THIS PROCEDURE BEFORE DISCONNECTING
THE ELECTRICITY
1. Disconnect the electricity.
2. Make sure that you have all the needed equipment.
3. Install the pin guides.
Figure 23 - Mounting the Chassis and Adaptor - Detail
Foxcom Proprietary Information
Document No. 93-006-01-A
Appendix III The 2380 Relay Adaptor
42