Threading The Upper Thread; Threading For Twin Needle - Husqvarna Viking Lena User Manual

Threading the Upper Thread

!
Turn off the main switch
Make sure the presser foot is raised and the
needle is in the up position
1. Pull the spool pin out. Place the thread
on the spool pin and the spool holder on
the spool pin as described. Push the spool
pin back in.
2. Bring the thread in the direction of the
arrow under the thread guide (a) and over
the thread guide (b).
3. Bring the thread down between the
thread tension discs.
4. Continue threading by drawing the thread
from the right into the slot on the take-up
lever.
5. Thread last guide just above the needle.
6. The needle is threaded from front to
back. The white on the presser foot
ankle makes it easy to see the eye of the
needle.
7. Place thread under the presser foot and
into the thread knife where it is cut.

Threading for Twin Needle

!
Turn off the main switch
1 Insert a twin needle. See page 11 Chang-
ing the Needle.
2 Use a second thread spool or wind a
bobbin with the thread you are going to
use as the second upper thread.
3
L : Thread the machine and
EFT NEEDLE
check to ensure that the thread lies bet-
ween the inner thread tension discs, and
inside the last thread guide. Thread the
left needle.
4 Attach the extra spool pin onto the
machine. Place a spool holder under the
thread.
5
Place the bobbin with the second thread
on the spool pin.
Procedures
4.
7.
6
R
IGHT NEEDLE
before but this thread should lie between
the outer thread tension discs, outside the
lowest thread guide. Thread right needle.
2.
a
b
3.
5.
6.
: Thread the machine as
1.
7