Door Reversal - Haier HVC15A User Manual

English
HVC15A

Door Reversal

1. Using a Phillips screw driver remove the upper hinge bracket by removing the screws and the hinge
cover on the bracket. (on the right side).
2. Lift and remove the door.
3. Remove the bottom hinge bracket by removing the 3 hexagonal nuts. Be careful not to loose the
door level rings which are placed in the hinge bracket axle. (right side).
4. Remove the lower door as shown in figure and install on opposite side.
5. To install the bottom hinge bracket on the opposite side (left side), you will also have to remove
screw hole plug from the left side.
6. Carefully align the bottom hinge axle hole on the door with the axle of the lower hinge bracket.
Remember to have the door level rings in place before you place the door on its axle.
7. Install the upper hinge bracket on the left side.
8. Make sure the door is aligned and then tighten the screws.
• For the HVCE15A remove and reinstall the door handle on the opposite side.
Replacing Light Bulb
1. Turn off and unplug the power cord of the wine cellar.
2. To remove the light bulb cover use a Phillips screw driver to remove the 3 screws.
3. Make sure the light bulb is cool before removing it. Replace using a light bulb 10 watts or less.
4. After the bulb is secure, install the light bulb cover and replace the three screws.
5. Turn unit on to its original setting after plugging in the power cord.
9
upper hinge
bracket
bottom hinge
bracket
lower door
bracket