Table of Contents
Advertisement
HOW TO ADJUST THE RESISTANCE STRAP
If there is not enough pedalling resistance when the
resistance knob is turned to the highest setting, the
Resistance Strap (47) may need to be adjusted. To
adjust the Resistance Strap, the left side shield must
first be removed. Refer to the instructions at the left
and remove the left side shield.
Next, turn the
resistance knob
to the lowest set-
ting. Locate and
17
open the Strap
Buckle (46). Grip
the end of the
Resistance Strap
(47) and pull it up
to remove any
slack. While
holding the end
of the Resistance Strap, fully close the Strap Buckle.
Turn the Crank (17) for a moment to make sure that
there is not too much resistance. When the Resis-
tance Strap is properly adjusted, reattach the left side
shield and pedal.
HOW TO ADJUST THE BELT
The exercise cycle features a precision belt that must
be kept properly adjusted. If the belt causes exces-
sive noise or slips as you pedal, the belt should be
checked. To do this, the left side shield must first be
removed. Refer to the instructions on page 12 and
47
46
remove the left
side shield.
Next, use an
adjustable
wrench to turn
the right pedal
counterclock-
wise and
remove it.
Remove the
right side
shield.
Press down on the centre of the Belt (16) between the
front and rear sprockets. There should be from 1/4Ó
to 3/4Ó of vertical movement in the centre of the
Belt.
If the Belt (16)
is properly
adjusted, reat-
tach the side
shields and ped-
als. If the Belt
needs to be
adjusted, loosen
the M10
Washer Nut
(34) on each
side of the
Flywheel (39). To tighten the Belt, turn the two M6
Nuts (37) clockwise; to loosen the belt, turn the Nuts
counterclockwise. Make sure that the Flywheel is
straight and tighten the M10 Washer Nuts (34). Reattach
the side shields and pedals.
13
16
16
34
39
37
Advertisement
Table of Contents
