Assembly Recommendations; Frame Assembly - Weider Wedier Pro 9635 User Manual

ASSEMBLY
Make Things Easier for Yourself
Everything in this manual is designed to ensure
that the weight system can be assembled suc-
cessfully by almost anyone. However, the weight
system has many parts and the assembly
process will take time. By setting aside plenty of
time, assembly will go smoothly.
Before beginning assembly, carefully read the
following information and instructions:
• Because of its weight and size, the weight sys-
tem should be assembled in the location where it
will be used. Make sure that there is enough
clearance to walk around the weight system as
you assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
1. Before beginning assembly, make sure
that you have read and understand the
information in the box above.
Locate and open the parts packet labeled

"FRAME ASSEMBLY."

Insert six M8 x 62mm Carriage Bolts (1) up
through the Stabilizer (5). Insert two M8 x
62mm Carriage Bolts up through the Base
(4).
Attach the Base (4) to the Stabilizer (5) with
two M8 x 67mm Bolts (11), two M8 Washers
(8), and two M8 Nylon Locknuts (3). Do not
tighten the Locknuts yet.
• As you assemble the weight system, make sure
all parts are oriented as shown in the drawings.
• Assembly requires two people.
• For help identifying small parts, use the PART
IDENTIFICATION CHART.
The included grease, and the following tools
(not included) may be required for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Clear tape or masking tape, and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
1
11
8
1
5
5
8
1
3
3
4
1